M audio profire lightbridge updating firmware

Driver DR is a professional Windows drivers download site, it supplies all devices for M-Audio and other manufacturers.

You can use two ways to download drivers and update drivers easily and quickly from here. Or you can use Driver Doctor to help you download and install your M-AUDIO Pro Fire 2626 drivers automatically.

Besides it is not supported for Mac Aggregate, AVID has taken it out of their program (as Presonus did it with the Lightpipe). People are quick to complain but usually it was driver issues and wrong clocking I believe. I will change to an RME Raydat when I can as I believe that will be more stable and I'm not too keen on firewire when recording critical things (one pull and it's out! I can offer a bit of insight into using both units over Fire Wire.

*Update* - Since i had the chance to buy a M-Audio Lightbridge for a very reasonable price i ordered it and will do the test, if it fails i can send it back. The firmware and drivers on the Pro Fire 2626 were optimized to provide higher performance and lower latency than similar devices based on the same chips sets.

Core Audio 0x98079028 HP_IOProc:: Call(Audio Time Stamp const&, Audio Time Stamp const&, Audio Buffer List const*, Audio Time Stamp const&, Audio Buffer List*) 374 2 com.apple.audio.

This optimization decreases the performance when aggregating multiple Fire Wire audio interfaces using Core Audio.

We've seen success with the Pro Fire 610 on newer systems but the bandwidth used by the higher I/O Pro Fire 2626 typically doesn't work when we aggregate two of them together.

You can use two ways to download drivers and update drivers easily and quickly from here. Or you can use Driver Doctor to help you download and install your M-AUDIO Pro Fire Lightbridge drivers automatically.

Hello, i am desperately searching an interface that i can use with the ES-3 module(s). The M-Audio Profire Lightbridge seems to be perfect, but the comments i found (crackling/pops/clock-problems) weren't so good - but most comments are already from 2009...

Leave a Reply